View Single Post
Unread 05-06-2004, 09:35 AM   #3
krazy
Cooling Savant
 
krazy's Avatar
 
Join Date: Mar 2003
Location: St. Paul, Minnesota, USA
Posts: 123
Default

I am familiar with the Danner Mag3, but I'm almost certain that the 500gph version has the same connections.

The Mag3 has 1/2" inlet and outlet as well, but they are not hose barbs. Rather they are 1/2"NPT tapered pipe thread. Assuming your pump uses the same style as the Mag3, you'll need a male and a female 1/2"npt--1/2"hose barb fittings. Mine needs one male and one female. The male fitting (the typical variety of barb everyone is used to) goes on the inlet, and the female fitting goes on the outlet.

Not the best picture to illustrate this, but whatever. Female-threaded barb in foreground, male-threaded barb in background,
__________________
Abit NF7-S ... xp1800+ ... Abit GF4ti4200 ... Maxtor 120gb SATA150
Currently gathering parts to water cool everything! (read about the project)
krazy is offline   Reply With Quote