Quote:
Originally Posted by Incoherent
A
...I am finding it extremely difficult to mount properly with the smaller die, I am getting tilted mounts rather frequently, .... However, for now I guess I just need practice.
|
I seem to be getting the hang of it. Best system seems to be to "dock" the die to the block keeping it flat by eye as the screws are tightened then turn on the heat. By minimising the TIM C/W readout the numbers seem to fall into place. Several days of this to go yet though, I am also concerned that I am cranking down a little too hard but it seems to be the only way to prevent WB C/W number giving nonsense. TIM measurements are going to be difficult.