Thread: Air trap pics
View Single Post
Unread 06-25-2002, 10:34 AM   #7
Cooling Savant
Join Date: Aug 2001
Location: MIami, Florida
Posts: 169

Thanks for the nice comments dcrain! I believe that placing the inlet at a higher point in the system would be a more efficient design. The initial bleeding of the circuit would be faster this way. However we are talking about a difference of a matter of hours between one design and the other. For the sake of expediency and simplicity I chose to have the intake at a lower point. Thge long term impact should be insignificant.

The pipe is a 1.5" plexi tube that can be purchased through Mcmaster/U.S. plastics/Tap Plastics etc. The fittings are clear PVC manufactured by Harvel Plastics.
hmale is offline   Reply With Quote