Pro/Forums - View Single Post

ricecrispi · 07-26-2006, 12:07 AM

a triple rad would get better performance by 5 C.

Coolingworks has lowest fpi at 12 and Bill adams put his expertise into design of coolingworks rads. This is the rad i would buy if you want to go for less expensive rad

thermochill rads have the largest dimension and so should get get the best temps but coolingworks whould be very close. I think these would be best for pelt setup and if you have the $$ than spring them out for this. Triple rad cost like $10 more than dual.

swiftech has the slimmest profile, about the same with BI pro. I think would perform the worst.

=========== and for mcp 350 pump==========

the 3/8th adapters wont give the same performace.
performance-pcs.com has alphacooling liang ddc pumps with plexitop for 1/2" ID barbs that will perform the same. Plus they are in the US, in florida and not in AU like Radiical.

07-26-2006, 12:07 AM	#10
ricecrispi Cooling Savant Join Date: Jul 2005 Location: california Posts: 429	Re: Final Peltier Setup, Suggestions Anyone? a triple rad would get better performance by 5 C. Coolingworks has lowest fpi at 12 and Bill adams put his expertise into design of coolingworks rads. This is the rad i would buy if you want to go for less expensive rad thermochill rads have the largest dimension and so should get get the best temps but coolingworks whould be very close. I think these would be best for pelt setup and if you have the $$ than spring them out for this. Triple rad cost like $10 more than dual. swiftech has the slimmest profile, about the same with BI pro. I think would perform the worst. =========== and for mcp 350 pump========== the 3/8th adapters wont give the same performace. performance-pcs.com has alphacooling liang ddc pumps with plexitop for 1/2" ID barbs that will perform the same. Plus they are in the US, in florida and not in AU like Radiical. Last edited by ricecrispi; 07-26-2006 at 12:14 AM.