Pro/Forums - View Single Post - home made water cooled 6600gt agp not 56k friendly

leejsmith · 03-22-2005, 02:05 AM

I tried to finish the block but both my cross vice and crappy piller drill have had it.
I think i could finish of the channles witht my dremel.

I was looking at a acrylic top mainly as i have a peice that would fit perfect.

I think the only problem with the copper sheet top would be any warping when soldering it to the base if it's too thin.

Is your 6600gt referance ? the xfx only has 4 holes 2 either side the gpu and 2 either side the agp/pci-e bridge chip. Not much to hold it at the top of the card.

I checked my collection of copper bits and i have a sheet of 1mm copper should be ok for the memory shim good idea

03-22-2005, 02:05 AM	#11
leejsmith Cooling Savant Join Date: Mar 2003 Location: notts uk Posts: 408	I tried to finish the block but both my cross vice and crappy piller drill have had it. I think i could finish of the channles witht my dremel. I was looking at a acrylic top mainly as i have a peice that would fit perfect. I think the only problem with the copper sheet top would be any warping when soldering it to the base if it's too thin. Is your 6600gt referance ? the xfx only has 4 holes 2 either side the gpu and 2 either side the agp/pci-e bridge chip. Not much to hold it at the top of the card. I checked my collection of copper bits and i have a sheet of 1mm copper should be ok for the memory shim good idea __________________ Folding , Folding , Folding !