Pro/Forums - View Single Post - Feed rate? Plunge rate? rpm? for 0.5mm bit

bigben2k · 05-12-2005, 02:19 PM

Glad to see you here; I was going to reply to your OC thread.

There's a calculator available at:
http://www.robbjack.com/

It's going to be mind-boggling slow...

05-12-2005, 02:19 PM	#2
bigben2k Responsible for 2% of all the posts here. Join Date: May 2002 Location: Texas, U.S.A. Posts: 8,302	Glad to see you here; I was going to reply to your OC thread. There's a calculator available at: http://www.robbjack.com/ It's going to be mind-boggling slow... __________________ WBTA (Water Block Testing Alliance) Nordic Hardware WC 101