Wow!
Four years! Another thanks for sharing the info on manuf. the block! When somebody puts that much time in something, and literary gives it to the people, what can I say, BIG THANX!
Thx for encouraging words.
Tomorrow I'm going to buy a nice plexy shield for my face, and remove that crappy blurry piece of plastic shielding drill chuck, one cannot see anything through that.
One question though, I have couple of 3 mm mill bits here, would it be any improvement if I try to drill the holes with those flat end mill bits? It would be much trickier to centre the bit over the hole without xy table, but is it worth to try?