HDD Block
So, here's the situation. The HDD waterblock is a bust. My design is flawed and i don't have the appropriate tools. So I'm replacing it with this:
SilentStar Dual HDD Cooling block + silencing enclosure.
I also just RMA'd my second (and louder) Atlas 10K III 18.2GB u160 scsi drive. It was waaaay louder than its identical brother, probably a bad bearing. Should have the advance replacement in a few days.
Cover Plates for Powdercoating Fowlup
Thanks to Zittware, and
This Thread, I have now sourced the transparent gray plexiglass I needed for the 'fowlup plates'. These plates cover the messups in teh powdercoat that went onto the jbwelded areas of the rear of the case. I should have it in my hands on April the 15th.
Here are the designs: (these are combined CAD dimensions with the graphics to be laser eteched on)
Covering the pump plug area:
And around the rear 120mm exhaust: