View Single Post
Unread 12-03-2002, 02:01 PM   #2
Cooling Savant
g.l.amour's Avatar
Join Date: Mar 2002
Location: on da case
Posts: 933
Default my second design

this is the first evolution of a block i am going to make. the first was very high flow.

-this one has been designed to have high flow resistance at a 1" diameter around the inlet point.
-at the outlets i have tried my best to keep things low flow resistance.
-i have kept the atlantis block in mind when designing this. it wouldn't show off the drawing, but atlantis is 2 barb, this is 3 barb so the spiral doesn't have to point one way but two way. (i haven't forgotten , BillA)

i hope the drawings make some sense. anyone who wants to have the source DWG file, pls ask.

the baseplate thickness isn't too important in the drawing, i will try make it as thin as possible around the die area.
yo soy un tiburón
g.l.amour is offline   Reply With Quote