View Single Post
Unread 02-20-2004, 09:43 PM   #143
spawningvat
Cooling Neophyte
 
Join Date: May 2003
Location: reading
Posts: 7
Default

here's my box

its kicking it w/ a 1700+thoroughbred B 1477mhz @ 2004mhz on a shuttle an35 ultra board,
1 gb of kingston valueram266@333 to match the processor,
ti4200 with bigger homemade aluminum heatsink,
Original Audigy card,
120gb Hitachi 8mb cache 180gxp(with only 6gbs LEFT) and a 45gb 5400 drive
Dvd and cdrw opticals


Watercooling stuff: Dtek tc-4, danner mag drive 3, sealed and all, cheapest core i could find-$16.88 fedco 2-150 8x6" i think, custom sweated male fittings for brass barbs, pvc res, with 1/2" fittings and tubing thru the system except for 3/4" to the pump intake.

Temps: Currently 36*c Proc, 33*c ambient case. Low: 27 proc, 25 case within the past week

A word to the wise-Don't seal your pvc res endcaps with epoxy because you didn't have the pvc welding cement on hand.

Sorry for all the detail, but this is the first post of the comp since i made it close to 8 months ago. Thats 8 months of dust and a few dog hairs for good measure. Can you tell i'm just a little excited.
Attached Images
File Type: jpg Vacuum2.jpg (88.1 KB, 106 views)
File Type: jpg watercooled2.jpg (94.3 KB, 185 views)
spawningvat is offline   Reply With Quote