Quote:
Originally posted by Jim
I left the "T" line open when I filled and bleed at first. DOn't allow the level of fluid to be too high, because in the beginning the thing burps and coolant shoots out.
After you think you are done filling, (the noise level of the pump dropping is a signal) then I fill the tube close to the top and cap it.
As air move up, the liquid level drops of course.
Jim
|
so..ok. leave cap off. fill. bleed. wait till fully bled (this is gonna take what..a few days?) then when fully bled, CAP IT. is that right?
and jim, you didn't tell me what the explanation was for not setting up the T like the above diagram