View Single Post
Unread 03-10-2005, 06:22 AM   #14
Hoot
Cooling Neophyte
 
Join Date: Dec 2002
Location: Twin Cities
Posts: 67
Default

You can get the voltage from anywhere you please. I have 5 pin IDC connectors with pigtails to run to your board. It plugs into the SMBus header with no soldering required. You're welcome to one under the same offer from the PM I sent you.

One thing you are going to have trouble with in your board design is the fact that these chips, regardless of who makes them are not .100 center stick-through packages like the board needs. They are extremely tiny surface mount devices. The .pdf file has the dimensions at the end. They can be, with a small soldering pen and for my old eyes a stereo microscope, soldered to a mini-dip component carrier and then mounted in a .100 center stick-through board. Again, same offer as in the PM..

Good luck with whatever you choose to do. The effort is well worth it.

Hoot
__________________
DFI LP UT NF4 Ultra-D 7.04-3 Bios
A64 3700+ San Diego 11x257 (2827 Mhz) @ 1.57Vcore
2x1Gb Crucial Ballistix 7:6 (300 Mhz) 3-3-3-8-1T @ 2.77V
Connect 3D x850xt 620/625
2x WD 36GB Raptors in Raid0
DIY Jet Impingement WB on CPU / Pipecap WB on GPU
Shrouded Camaro Heater Core / Swiftech MCP655 Pump
Antec P-160 Tower / Seasonic S12 600W PSU
MAXIM 6658 Thermal Diode Reader
Moderator at OCForums
Hoot is offline   Reply With Quote