Upgrading the drives in my SNAP has been a partial success. Original 2 16gig drives were replaced with a couple 120gig western digitals. The SNAP fires up fine but only sees them as 38gig or so each. I'm not sure what model number it is, 1000 or 1100 because it doesn't have the markings on the outside of the case that most do.
SNAPs document for the 4100,
4100__disdrive.pdf has some information on pages 7 to 9 on using the
reinit command. I tried it but it didn't change anything. It could be that I didn't have the correct information in the config device format 100## /reinit /nocore command line or that this is not the correct command to change the size of the drives.
I plan on another attempt this weekend since the SNAP is down and apart to replace the CPU fan. eMail me if anyone is able to come up with commands that worked or might work for me.
forum@ezend.com
Thanks,
Don