Pro/Forums - View Single Post

ibmkg · 09-28-2007, 04:18 PM

please pass a link for a hole saw that you recomend... I have never seen one that can go as far as 4inches. The ones I have would go 8mm max.

Where can I get those xy table? I am dying to get my hands on something like that. Perhaps if I go easy, I can make fairly complex designs with such a tool. Will it fit any drill press?

I would use rubber sheets. I do not have a dremel.

Currently I have two Copper plates lying around. One is 4inch wide, 15inch long and 1 inch thick.

Other is 50mm wide, 6inch long and 1 inch thick.

Is there any 'in home' method to lap? These Cu plates have deep pits and using a sanding paper did not do the job (lapped for hours but...)

09-28-2007, 04:18 PM	#12
ibmkg Cooling Savant Join Date: Jan 2005 Location: USA Posts: 129	Re: Help with making new water block please pass a link for a hole saw that you recomend... I have never seen one that can go as far as 4inches. The ones I have would go 8mm max. Where can I get those xy table? I am dying to get my hands on something like that. Perhaps if I go easy, I can make fairly complex designs with such a tool. Will it fit any drill press? I would use rubber sheets. I do not have a dremel. Currently I have two Copper plates lying around. One is 4inch wide, 15inch long and 1 inch thick. Other is 50mm wide, 6inch long and 1 inch thick. Is there any 'in home' method to lap? These Cu plates have deep pits and using a sanding paper did not do the job (lapped for hours but...) __________________ NOTE: Suggestions are based on my perceptive. I could be erroneous. Therefore, no one has the right to criticize an individual other than rephrasing and or expressing his own annotations on the subject matter itself.