Quote:
Originally posted by Puzzdre
I think that you'll be better with two outlets on the opposite sides, and maybe with a little smaller (in height) cap, just to get the water faster out of the block...
|
One of the main design goals was to make it quick and easy, and only one outlet helps that. The sixteen 1.2 X 4mm channels are several times more restrictive than the 10.5 mm ID of the outlet pipe, so flow should be very even between them. In this case a higher cap helps because distance from channels exit is more similar.
My next step should be making a copper disc with the same channels to be a replacement base for my
previous block, which uses four outlets.
Actually I’m leak testing it, so maybe later today could be some results.
