Quote:
Originally posted by bigben2k
That's most interesting! Thanks, I can use that info!
What distance did you have between the 3/8 opening and the top of the CPU? Some of the info I've seen points towards a ratio of 10:1 (distance to opening size).
|
it was about 6mm above the core, the multiple jets were about half that away.
Quote:
Thanks for taking the time to test that out Volenti. man you must really spend A LOT of your time on all this.
Was this test conducted with your new 3 stage pump or with a single pump? Are you going back to the jet design or a newer jet design?
|
The 3 stage pump is currently in bits while I work on a better valve setup, for the test I used a (surprisingly un-modified) 740GPH/8.5' head pond pump. ( have used that pump before with the mulitple jets as well)
I'll make a new block that will have provision for (hopefully) easy jet changes as well as stepping up to 1/2'' inlets/outlets (to make my plumbing a bit easier more than anything)