Pro/Forums - View Single Post

Socko · 11-06-2003, 10:43 PM

I decided to just go side in side out. The middle plate probably won't be able to distribute water to all the fins well enough, so I scrapped ideas for a third barb. I would remove some of the pins, but this block is for a Athlon 64, so I would prefer not to.

P.S. I already know that the holes don't match up with A64 boards, so I'm getting a Leadtek one that has the original 4 holes in the board.

11-06-2003, 10:43 PM	#13
Socko Cooling Neophyte Join Date: Nov 2003 Location: Vineland, NJ Posts: 19	I decided to just go side in side out. The middle plate probably won't be able to distribute water to all the fins well enough, so I scrapped ideas for a third barb. I would remove some of the pins, but this block is for a Athlon 64, so I would prefer not to. P.S. I already know that the holes don't match up with A64 boards, so I'm getting a Leadtek one that has the original 4 holes in the board.