I'm thinking of making one...
ok doing more then thinking...
done all thd measuring parted already and planned out the flow..
simular to leejsmith...
before I order any copper..
The base I have roughed out at 4"x4.5" and .5" thick...
Also where the ram is lower then the GPU I plan to use some copper shims also 0.048" (18 ga.) thick...
how think should I make the top piece?
I was thinking 0.048" (18 ga.) copper sheet
any thoughts?
__________________
"Great spirits have always encountered violent
opposition from mediocre minds" - (Einstein)
|