Quote:
Originally Posted by Cathar
Your specs are indeed showing that G1/4 is the same as 1/4" BSP, which is what I used.
|
Oops, you wrote 1/4 BSP i did read 1/4 NPT.
Quote:
Originally Posted by Cathar
So a little unsure about your statement about me needing to be careful about it, unless you're talking about US people attempting to crank in 1/4" NPT threaded barbs into a G1/4 threaded hole.
|
Yes, i was talking about to use tapered screws into parallel holes, because G1/4 Major Diameter is 13.157 mm so a NPT Thread Barb could be introduced and forced to crank. Pitch difference and growing diameter would force thread hole.
BTW, there is a BSPT (R1/4 - BSP Tapered), which use same pitch 19, same Major Diameter, but with Tapered Thread...
just for users knowledge...
Quote:
Originally Posted by Breach
|