I don't want to start a new topic for this, but I was just reading some topics and I saw you were talking about cascade designs en the opposite of it.
You can see my current design in the pic. But I'm a bit bored so I want to build a new one. What design should I go for. I don't want to make blokcs in copper, cuz' I love aluminum, and copper is kinda hard to work with, when you have just a drillpress and a dremel...
The pin-thing works a lot better than I was expecting. A delta of... let's say, something around 7°C.
so the main question... what design should I go for as second block...
I would like to keep 2 connections for inlet an 2 for outlet. It's possible to make a Y to get one entrance if neccesairy(don't know if I wrote it correct
)
grtz