Pro/Forums - View Single Post

Fixittt · 09-20-2002, 06:10 PM

Prolly went to fast. And also if it was done on a "Cheaper" drill press. And you didnt use a level to make sure that the table and part were PERFECTLY flat then that might be what happened. You drilled in deep, flexing the skinny drill bit and.......... SNAP! Putting the block in the freezer really didnt do anything, as I am pretty sure that the block was above room temp before the first hole was drilled thrue.

09-20-2002, 06:10 PM	#2
Fixittt CNC Beyatch Join Date: Aug 2001 Location: Tulsa Spell it backwards Posts: 721	Prolly went to fast. And also if it was done on a "Cheaper" drill press. And you didnt use a level to make sure that the table and part were PERFECTLY flat then that might be what happened. You drilled in deep, flexing the skinny drill bit and.......... SNAP! Putting the block in the freezer really didnt do anything, as I am pretty sure that the block was above room temp before the first hole was drilled thrue. __________________ Creator of the Spir@l Block Longest post ever http://forums.procooling.com/vbb/showthread.php?s=&postid=43808#post43808