Almost There!
The touch keys are almost done, very little left. Final integration will be when I install/assembled the new bezel. Laser cut parts are on there way from Oregon (mountain mods - ben kicks ass!) and are slated to arrive on wednesday of next week (the 30th). I'd expect to have a new update a day or 3 after that.
Keys prepared for having their bottoms painted
Thank god for the warmer weather, but I still have to heat the paint up - rustoleum satin black sitting in my laundry sink (the black thing is the washers' waste water tube) full of hot water.
Ready to rock!
Keys painted
Oh... that worked well - money shot (note no light leaking out the bottom now)
Death by electrodes?
The touch keys have to connect back to the QT150 somehow, so I've got to attach wire to my electrodes. The average soldering iron (and obviously not what I have - hakko 936) can't heat up a penny enough to solder to it... but a propane torch can!
Ready to solder - don't try this at home, kids. This is all the stuff I took outside to the concrete back porch. The wife would get kinda pissed if I burnt the house down, ya dig?
*Squints* look real close and you can see the propane flame. The bright side (pardon the pun) is that the solder burnt off all the crap on the penny - I had a feeling it would, which is why I didn't prep/polish them beforehand.
First one soldered - 24AWG stranded copper for flexibility