Pro/Forums - View Single Post - New block design, low profile, hard lined

Spaceraver · 04-22-2006, 03:49 PM

This is just a Inventor render, but i'll make the dwg files available if someone want's them.. I can make a zip file with the whole package, that would be Inventor files ie. .iam, .ipt as i haven't made the dwg files yet... The reason the tubes are so long is that they have to be so close to the base as possible, 1 mm from them atm... but bottom plate could be made 2 mm lower, it was just to acommodate the 12mm copper tube without it breaking, but 2 mm "flesh" on either side should suffice..

04-22-2006, 03:49 PM	#3
Spaceraver Cooling Neophyte Join Date: Feb 2006 Location: Denmark Posts: 18	Re: New block design, low profile, hard lined This is just a Inventor render, but i'll make the dwg files available if someone want's them.. I can make a zip file with the whole package, that would be Inventor files ie. .iam, .ipt as i haven't made the dwg files yet... The reason the tubes are so long is that they have to be so close to the base as possible, 1 mm from them atm... but bottom plate could be made 2 mm lower, it was just to acommodate the 12mm copper tube without it breaking, but 2 mm "flesh" on either side should suffice..