Quote:
Originally posted by bigben2k
But the opposite is also true: you'll increase the boundary layer on the other side of the channel. Effect cancelled.
|
This is maybe a stupid bet, but I hope that the benefit in the outer side of the channel is more than drawback on the inner side.
About capillars: remember that my channel widht is the same as in radius.
Quote:
Originally posted by bigben2k
You should make that central post a pin, otherwise the incoming coolant will spray all around it, ignoring the pin's hot base.
|
That's on the go, now that I'm free from geometric limitations of milling, I'm going to use full NURBS surfaces modelling software.
Consider the images I posted as a first rough sketch
