View Single Post
Unread 07-04-2003, 06:35 PM   #184
Responsible for 2%
of all the posts here.
bigben2k's Avatar
Join Date: May 2002
Location: Texas, U.S.A.
Posts: 8,302

1st build: failure!

The driver is outputting only 4 volts, with a 5 volt supply.

The MOSFET is outputting 1 volt.

I think that the driver was a bad choice. I'm not convinced that this "pump-charge" was designed to output a steady voltage.

I'll try again, with another assembly, with the MOSFET in reverse.
bigben2k is offline   Reply With Quote