[blue68f100]

OK, here are some of my picture of my 19" rack that I bought on eBay, local pickup for $9 and 10 minutes from my house. This came with sides and doors and a 4' plug strip

Pardon all of the stuff I have in my garage.

I used angle Iron for the bottom frame, inserted a 1" MDX bottom with caster rated for 200lbs x 4.


Finished with a Oak Door and acrylic panel. As you can see I cut the side panels down and did the breaks for the sides to fit. This rack is heavy with out the equipment ~100lbs. Luckly I have a commercial grade carpet squares in this room so chairs and my rack rolls.

Maxfior:
If you are going to make your own you need the rails (Ft & Back) and the side (horz) pices so you can position the rails.