Pro/Forums - View Single Post

Puzzdre · 05-20-2003, 02:40 AM

The barbs are made in one machine shop here, locally, and the id is (for this blocks) 10 mm, and the threaded end is 16 x 1.5 (it's supposed to be very similar to 3/8, the 16 x 1.5 is widely used here for hydraulic applications). I cannot drill them wider, cos the upper part is made to accept the 12 mm tube, so it's too thin. On the other hand, last time I got him to make me several pieces of 10 mm ID, and several of 12 mm ID, both with same threaded end, so if there's any need for larger ID, no prob. unless the ID wanted is not wider than 14 mm or little less.

Cheers!

05-20-2003, 02:40 AM	#31
Puzzdre Cooling Savant Join Date: Aug 2002 Location: Croatia Posts: 969	The barbs are made in one machine shop here, locally, and the id is (for this blocks) 10 mm, and the threaded end is 16 x 1.5 (it's supposed to be very similar to 3/8, the 16 x 1.5 is widely used here for hydraulic applications). I cannot drill them wider, cos the upper part is made to accept the 12 mm tube, so it's too thin. On the other hand, last time I got him to make me several pieces of 10 mm ID, and several of 12 mm ID, both with same threaded end, so if there's any need for larger ID, no prob. unless the ID wanted is not wider than 14 mm or little less. Cheers! __________________ 'Out of cheese error... ...please reboot the universe (press the GBL to continue)' Last edited by Puzzdre; 05-21-2003 at 02:58 AM.