Pro/Forums - View Single Post

Zymrgy · 05-01-2003, 11:28 PM

& also, to Balinju & bigben2k, is this what you had in mind?

Now, all I did was switch the places from the "channel" & the "walls". I also added the tapered sides in, however, while not being impossable, they would be a pain in the ass to make that way, to say the least. Remember each channel is only .040 wide (1mm). Something more feasable might be to "step" the width down...this would allow me to make the fins taller as a bonus.

05-01-2003, 11:28 PM	#10
Zymrgy Cooling Neophyte Join Date: Apr 2003 Location: USA Posts: 96	& also, to Balinju & bigben2k, is this what you had in mind? Now, all I did was switch the places from the "channel" & the "walls". I also added the tapered sides in, however, while not being impossable, they would be a pain in the ass to make that way, to say the least. Remember each channel is only .040 wide (1mm). Something more feasable might be to "step" the width down...this would allow me to make the fins taller as a bonus.