Quote:
Originally posted by bigben2k
I had a crazy idea this morning: what if I used this new flow seperator, the one that drops into the channels, and reverse the flow? I'd have a jet directed at that deadspot!
Problem is, the baseplate is actually hotter than the fins, so the center inlet is actually best: the jet works best against a hot surface, not along it's side. Oh well.
|
How about this. Cut your fins just right where they meet in the middle so you end up with a circle pin dead center. Raise this pin slightly higher than the fins so it's just poking up through your nozzle. An idea I was thinking about trying with mine. I don't know if it would work but you never know.