Quote:
|
Originally Posted by Cathar
Have a poke through that paper I linked to above for more information.
|
Looks like we're somewhat on the same page. I'v seen this one and used it to base my block on also. Though quite different from your cascade design, performs just as good.
What would be interesting is to try a capillary tube design in an array that would benefit pelts but be interchangable plates to use in a IHS design. Machining that would be a nightmare though. I'v got a decent design in the works using that idea but you can forget using any pump less than a L30 or equivilent as it restricts flow to much. Not to the mention the amount of drill bits I killed. Now if i had access to a laser.
Intel has a good white paper you might be interested in also. If I can dig it up again from them I'll post a link to it. It's an interesting read.