View Single Post
Unread 11-06-2003, 03:56 PM   #44
jaydee
Put up or Shut Up
 
jaydee's Avatar
 
Join Date: Dec 2001
Location: Spokane WA
Posts: 6,506
Default

Quote:
Originally posted by tex707
OK, jaydee....how about this impossible-to-machine version of your NB waterblock...???....
That is pretty damn cool! It is millable but not sure I can do it.

Quote:
Originally posted by tex707
Well...the difference between 1.65" and 1.67" is marginal....if you have just a little bit of play between the bolt and the holes in the motherboard, it could pass unnoticed.

Of course, I'll change my 3D motherboard model according to your measurements...
Yeah it souldn't matter. I am not sure which is to specs but I know mine works. The holes line up perfectly with the HS holes. Also note this is slightly different than the first block in the zip file. I had 2.38" diagnaly on it and this one is 2.33". I am concerned about the ASUS and ABIT board i got at home which these blocks are being built for. If this ASUS A7V333 has different specs it is almost a given the ASUS A7V8X-X has the same. If that is the case I will have some remodeling to do as the holes are much tighter... Will check it out later tonight when I get a chance.
jaydee is offline   Reply With Quote