Quote:
Originally Posted by Ls7corvete
Yea just what I mean, a classic design adapted to casting. What about running a couple inches of hard copper pipe out of the block? You could even sweat some 90s on there to make it over the card, the copper 90s have a pretty nice curve to them.
|
thats exactly what i was planning anyway, just to solder or braze in some tubing with a little bend in each of them to bring the tubing up above the card and a little angle on them so theyre not too close to the part of the card the tubing will pass over, i did that with my last block though the card it was meant for was smaller than my current one (just a 9600 pro)