how are these temps?

res0r9lm · 03-17-2002, 05:32 PM

are these temps ok for water cooling? ok this is with tbird not an xp and also folding.

res0r9lm · 03-17-2002, 05:35 PM

here is another with ahigher overclock and vcore

jaydee · 03-17-2002, 06:13 PM

Depending on the equipment and the enviroment you are in I would say those are decent temps. What is the setup you are using?

Brad · 03-17-2002, 09:09 PM

I reckon those temps are quite good, but it might just be your diode thats out

res0r9lm · 03-18-2002, 10:34 AM

Quote:

Originally posted by jaydee116
Depending on the equipment and the enviroment you are in I would say those are decent temps. What is the setup you are using?

actually it is aircooled using a duct. 120mm at one end and a delta 80 mm at the other. still getting stuff up to go watercooling. right now I'm short a pump and a block. this is what I plan on ehiem 1250, dangerden maze2, blackice rad, all using 1/2'' hose. I see alot of people putting down air cooling but it can be good if done right but watercooling is much better and I think I'm at the limits of aircooling.
I have all the stuff for my duron already except I need a heater core for it. don't want to use the blackice in that case b/c it's a much bigger case while the other is only a mid tower. plus the duron will be using only 3/8" hose and I have already modded the blackice with 1/2" fittings.
I would like to get under 35c under load with a room temp of 24c-25c

Brad · 03-18-2002, 12:44 PM

using air those temps are really good, what cfm are those fans? the loud ones?

res0r9lm · 03-18-2002, 01:11 PM

Quote:

Originally posted by Brad
using air those temps are really good, what cfm are those fans? the loud ones?

the 120mm is a radio shack fan I'm not sure of cfm but I believe it's only 86cfm. (I would never recommend radio shacks fans a panaflo would be a better choose I have another system using a panaflo H1 without a fan on heatsink and it is very quiet) on the other end I have an 80mm delta 68cfm the funny thing is the fan are cancelling some of the noise or it is the duct b/c it sounds about the same as a swifty mc 462 with the delta's before I was using a 60mm instead of the 80mm and it was louder.

03-17-2002, 09:09 PM	#4
Brad Thermophile Join Date: Oct 2001 Location: Nuu Zeeelin Posts: 3,175	I reckon those temps are quite good, but it might just be your diode thats out __________________ 2x P3 1100's at 1400, Abit VP6, 2x Corsair 256mb PC150 sticks, 20gb 'cuda ATA-III, 2x 40gb 'cuda ATA-IV in raid 0. 20" Trinitron. No fans 2x 2400+ at 2288mhz (16.0 x 143), Iwill MPX2, 2x Kingmax PC-3200 256mb sticks, 4x 20gb 60gxp in Raid 5 on a Promise SX6000. Asus Ti4200 320/630. Cooled by Water

03-18-2002, 12:44 PM	#6
Brad Thermophile Join Date: Oct 2001 Location: Nuu Zeeelin Posts: 3,175	using air those temps are really good, what cfm are those fans? the loud ones? __________________ 2x P3 1100's at 1400, Abit VP6, 2x Corsair 256mb PC150 sticks, 20gb 'cuda ATA-III, 2x 40gb 'cuda ATA-IV in raid 0. 20" Trinitron. No fans 2x 2400+ at 2288mhz (16.0 x 143), Iwill MPX2, 2x Kingmax PC-3200 256mb sticks, 4x 20gb 60gxp in Raid 5 on a Promise SX6000. Asus Ti4200 320/630. Cooled by Water

03-17-2002, 06:13 PM	#3
jaydee Put up or Shut Up Join Date: Dec 2001 Location: Spokane WA Posts: 6,506	Depending on the equipment and the enviroment you are in I would say those are decent temps. What is the setup you are using?

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)