Go Back   Pro/Forums > ProCooling Technical Discussions > General Liquid/Water Cooling Discussion
Password
Register FAQ Members List Calendar JavaChat Mark Forums Read

General Liquid/Water Cooling Discussion For discussion about Full Cooling System kits, or general cooling topics. Keep specific cooling items like pumps, radiators, etc... in their specific forums.

Reply
Thread Tools
Unread 02-02-2003, 02:29 PM   #1
artemis0007
Cooling Savant
 
artemis0007's Avatar
 
Join Date: Sep 2001
Location: Davis, CA USA
Posts: 113
Default PC-35 case, 3 GHz and a BI Micro?

Hi All!

I'm in quite a pickle. I have a Lian Li PC-35 case and I have a P4 3.06 GHz proc. Currently I'm using a Vantec AeroFlow HSF but it's not doing the job. See the PSU is about 1 mm above the HSF intake so I have some problems (55C idle 70C load | my overheat alarm goes off at 60C, very loud).

I was thinking of doing a micro watercooling setup. It will just cool the proc and nothing else. I was thinking of using the Black Ice Micro but I'm not sure if it'll even do the job any better.

Any suggestions or comments would be appreciated. I have very very little space in here. Thanks!
__________________
Pentium 4 3.06 GHz watercooled by Koolance EXOS
Gigabyte 8INXP mobo
512MB Corsair PC3200 DDR RAM
Fortron 400W PSU
Watercooled Radeon 9700 Pro
Quiet as a mouse!
Koolance Temps: 26C/32C
BIOS Temps: 36C/44C
==========================
Dual Athlon MP 2000+ watercooled
Black Ice Extreme, Eheim 1250 pump, 2 DTek TC-4 blocks, and homemade res
Gigabyte GA-7DPWDX mobo
512 MB Registered Mushkin DDR 2100 RAM
RAID 0: 2 IBM 60 GXP 60GB ea
RAID 5: 3 Western Digital Caviar 60GB ea
MSI GeForce4 4400
Sound Blaster Audigy MP3+
Yamaha CDRW-F1
Adaptec ATA RAID 2100 card
LOADS OF FANS!!!!
artemis0007 is offline   Reply With Quote
Unread 02-03-2003, 02:06 PM   #2
jtroutma
Cooling Savant
 
jtroutma's Avatar
 
Join Date: Aug 2001
Location: SLO, CA
Posts: 837
Default

Well, here is something that MIGHT work. BI micro with a Vantect Tornado 92mm w/ 92mm -> 80mm shroud. That way you could also setup a potenometer to the tornado to control the noise a bit more. That might work but requires some head room.

Otherwise, a BI micro w/ an 80mm tornado with a voltage dial. I am looking into building a cooling system very similar into a Shuttle SN41G2 and I think that it will work.

BTW dont expect stellar temps with that setup but should be better than what you have there.
__________________
Athlon64 X2 4200+ @ 2.5Ghz (250FSB x 10)
OCZ VX 1GB 4000 @ 250FSB (6-2-2-2 timmings)
DFI LANParty nForce4 Ultra-D
SCSI Raid 5 x (3) Cheetah 15K HDDs
LSI Express 500 (128MB cache)
OCZ PowerStream 520W PSU
ATI X850XT PE (Stock)
DTEK WhiteWater + DTEK Custom Radiator
Eheim 1250
jtroutma is offline   Reply With Quote
Unread 02-03-2003, 09:54 PM   #3
redleader
Thermophile
 
Join Date: Jun 2001
Location: The deserts of Tucson, Az
Posts: 1,264
Default

Quote:
I was thinking of using the Black Ice Micro but I'm not sure if it'll even do the job any better.
Save your money.
redleader is offline   Reply With Quote
Unread 02-04-2003, 12:11 AM   #4
cybrsamurai
Cooling Savant
 
cybrsamurai's Avatar
 
Join Date: Jan 2002
Location: Ashland
Posts: 296
Default

I think it would definitely work better than what you are using now as you will have a much larger (in volume) heat sink and you will have more options for cooling as you wont have a restricted air flow. Most P4 3.06Ghz CPUs produce between 50 - 85W of heat. The Black Ice Micro is rated for "236.6 KCal per hour (938.89 BTU per hour) or 275W" It should be fine according to specs...
__________________
Air cooled my ass.
cybrsamurai is offline   Reply With Quote
Unread 02-04-2003, 01:21 AM   #5
msv
Cooling Savant
 
msv's Avatar
 
Join Date: Dec 2002
Location: Sweden
Posts: 336
Default

I´m thinking of the BI Micro for my own computer (WC for silence, not for performance). HW Labs usually state their rads performance at an airflow of 100 CFM. 275 watts may well be possible, but it´s gonna be loud.
www.hwlabscom list a couple of tests of their rads, the Micro as well. Unfortunately (just checked it) they removed the link to a review of a single Micro and a 26 CFM 80 mm fan (I mailed the author and asked), that cooled a mildly overclocked Duron to some 45 degrees Celsius (don´t know what that is in Farenheit).
Hope it gives You some ideas.
Regards
Mikael S.
msv is offline   Reply With Quote
Unread 02-09-2003, 03:41 PM   #6
redleader
Thermophile
 
Join Date: Jun 2001
Location: The deserts of Tucson, Az
Posts: 1,264
Default

Quote:
The Black Ice Micro is rated for "236.6 KCal per hour (938.89 BTU per hour) or 275W" It should be fine according to specs...
I noticed you didn't mention an air flow or temperature needed to move that amount of heat. Let me guess 150 CFM (through an 80mm fan) and a coolant temp of just 50C degrees. If it leaks you'll be scalded
redleader is offline   Reply With Quote
Unread 02-09-2003, 04:13 PM   #7
cybrsamurai
Cooling Savant
 
cybrsamurai's Avatar
 
Join Date: Jan 2002
Location: Ashland
Posts: 296
Default

didnt post the info because i didnt have it I still think its going to work better than a flow restricted heat sink.
__________________
Air cooled my ass.
cybrsamurai is offline   Reply With Quote
Unread 02-09-2003, 07:34 PM   #8
artemis0007
Cooling Savant
 
artemis0007's Avatar
 
Join Date: Sep 2001
Location: Davis, CA USA
Posts: 113
Default

Hi all!

Thanks for all of the replies! I'll give an update of my situation to give this thread some closure.

My friend had an unopened Koolance EXOS that was supposed to be for his computer but his computer broke on him. Soooo he let me buy his Koolance EXOS for $150 (including the waterblock) and my HSF that I was replacing so he could use the $$$ to replace mobo.

I'm getting pretty decent temps with the EXOS (waaay better than before). The temp probe says my CPU is at 26C idle but I think it is more like 36C - 40C.

Again, thanks for all of the posts!!!!
__________________
Pentium 4 3.06 GHz watercooled by Koolance EXOS
Gigabyte 8INXP mobo
512MB Corsair PC3200 DDR RAM
Fortron 400W PSU
Watercooled Radeon 9700 Pro
Quiet as a mouse!
Koolance Temps: 26C/32C
BIOS Temps: 36C/44C
==========================
Dual Athlon MP 2000+ watercooled
Black Ice Extreme, Eheim 1250 pump, 2 DTek TC-4 blocks, and homemade res
Gigabyte GA-7DPWDX mobo
512 MB Registered Mushkin DDR 2100 RAM
RAID 0: 2 IBM 60 GXP 60GB ea
RAID 5: 3 Western Digital Caviar 60GB ea
MSI GeForce4 4400
Sound Blaster Audigy MP3+
Yamaha CDRW-F1
Adaptec ATA RAID 2100 card
LOADS OF FANS!!!!
artemis0007 is offline   Reply With Quote
Reply


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT -5. The time now is 04:09 PM.


Powered by vBulletin® Version 3.7.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
(C) 2005 ProCooling.com
If we in some way offend you, insult you or your people, screw your mom, beat up your dad, or poop on your porch... we're sorry... we were probably really drunk...
Oh and dont steal our content bitches! Don't give us a reason to pee in your open car window this summer...