can I use a tec without a coldplate?

qwerty57 · 05-01-2003, 12:49 PM

like this:

block
tec
northbridge

or do you "HAVE" to 100% use a cold plate?? assuming that the right pressue is apllyed..

bigben2k · 05-01-2003, 12:54 PM

100%, you have to.

The cold plate, aka spacer, also acts as a heat spreader. Also, I really don't think that you would want to subject your mobo/NB to the kind of clamping pressures that are required. As a guide, nylon bolts can barely handle the pressure themselves!

RoboTech · 05-01-2003, 05:05 PM

IMHO you don't have to use a cold plate - it won't be very efficient, but it won't hurt anything. The purpose of the cold plate is to act as a heat spreader (as Ben said) which couples the relatively large surface area of the TEC cold side to the much smaller surface (NB???) you are trying to cool. Any of the TEC cold side that is not in direct contact won't be able to transfer heat. It will have to be well insulated because it's exposed and will get cold = condensation.

The cold plate also acts as a thermal buffer - to help moderate temperature changes.

On the other hand, the hot side of the TEC "HAS" to 100% be in contact with a heatsink or it can overheat the couples and burn out.

(I won't ask why...

) Good luck

MadDogMe · 05-10-2003, 02:49 AM

It's hard to get the optimal clamping pressure of 100PSI+ if you don't...

05-01-2003, 12:49 PM	#1
qwerty57 Cooling Neophyte Join Date: Apr 2003 Location: hollywood, fl Posts: 40	can I use a tec without a coldplate? like this: block tec northbridge or do you "HAVE" to 100% use a cold plate?? assuming that the right pressue is apllyed..

05-01-2003, 12:54 PM	#2
bigben2k Responsible for 2% of all the posts here. Join Date: May 2002 Location: Texas, U.S.A. Posts: 8,302	100%, you have to. The cold plate, aka spacer, also acts as a heat spreader. Also, I really don't think that you would want to subject your mobo/NB to the kind of clamping pressures that are required. As a guide, nylon bolts can barely handle the pressure themselves! __________________ WBTA (Water Block Testing Alliance) Nordic Hardware WC 101

05-01-2003, 05:05 PM	#3
RoboTech Cooling Savant Join Date: Sep 2002 Location: Cincinnati, OH Posts: 229	IMHO you don't have to use a cold plate - it won't be very efficient, but it won't hurt anything. The purpose of the cold plate is to act as a heat spreader (as Ben said) which couples the relatively large surface area of the TEC cold side to the much smaller surface (NB???) you are trying to cool. Any of the TEC cold side that is not in direct contact won't be able to transfer heat. It will have to be well insulated because it's exposed and will get cold = condensation. The cold plate also acts as a thermal buffer - to help moderate temperature changes. On the other hand, the hot side of the TEC "HAS" to 100% be in contact with a heatsink or it can overheat the couples and burn out. (I won't ask why... ) Good luck

05-10-2003, 02:49 AM	#4
MadDogMe Thermophile Join Date: Aug 2002 Location: Just shut up ;) ... Posts: 1,068	It's hard to get the optimal clamping pressure of 100PSI+ if you don't...

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)