|
|
Heatsink/ Heat Pipe / ThermoSiphon Cooling The cat will only make the mistake of putting its paw by your HSF once. :) Also the place to discuss the new high end heat pipe goodness. |
Thread Tools |
05-22-2003, 02:49 PM | #1 |
Cooling Savant
Join Date: Jun 2001
Location: Spring Hill, FL
Posts: 169
|
Replacing speed dial with toggle switch
Is it possible to replace the little screw dial on enermax adjustable fans with a two or three way switch?
What items would i need and what would i need to do...? |
05-22-2003, 03:38 PM | #2 |
Big PlayerMaking Big Money
Join Date: Aug 2001
Location: irc.lostgeek.com #procooling.com
Posts: 4,782
|
Yea should be possible. Just put resistors of different values between the wire from the enermax and the switch. Cut off the current potentiometer and measure the maximum resistance of it and vary the resistors to hit a nice range of speeds. No resistor would be full power in that case.
|
05-22-2003, 05:21 PM | #3 |
Cooling Savant
Join Date: Jun 2001
Location: Spring Hill, FL
Posts: 169
|
how could i do it. i know there are two wires leading to the adjuster screw, but what terminals would i connect it to on a SPST switch? in ohter words, what wire goes on what terminal?
|
05-22-2003, 06:34 PM | #4 |
Cooling Savant
Join Date: Jun 2001
Location: Spring Hill, FL
Posts: 169
|
i've been looking around and was wondering if this would work... .
|
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|