Home made waterblocks

[Stooo]

Originally Posted by |kbn|

Would anyone in the UK be able to sell me some copper? There are no shops selling it near me and I dont have a car..

I need..
~3/16th" thick (~5mm) +-2mm
~1 1/2 - 2" wide (~40-50mm) +-10mm
~3" (70mm) long or longer so I can make one or two, maybe three blocks.

Also need a 11-12mm drill bit and a 1/2" BSP tap, might get these from a near shop though.

I would pay all postage and enough to make it worth the effort

too bad your not in the us I've got plenty
see this thread

[|kbn|]

Thanks Butcher, Ive emailed them for a quote for 1/4"x4"x12"

Today I finnished the gpu block. The base is almost perfectly flat, spent about an hour lapping to 1500 grit then I pollished it with silvo. I tryed to take a pic of the finnish but it was too shiny and shows half of my monitor.
It was leak tested under full flow of mains water from bath tap for 5 mins and didnt passed. I might paint the plastic top blue to get rid of the green pen by the barbs. Ill probably put it back on gfx card later this week.
Also a pic of my new heatercore with the old one. Spent the morning cleaning that up.