best way to seal tygon/acrylic joint?

lel4866 · 06-28-2003, 03:38 PM

I have an acrylic reservoir where I'm feeding some tygon r-1000 tubing out of the bottom (to feed the pump). The tygon and hole in the acrylic are the same size (1/2"), and the fit is pretty tight. What's the best sealant? I have some regular Home Depot GE Silicone II. Is there something better?

Larry Lewis

Cyco-Dude · 06-28-2003, 04:07 PM

well, you could try using plumbers goop.

would it be possible to put a barb into the res??

06-28-2003, 03:38 PM	#1
lel4866 Cooling Neophyte Join Date: Jun 2003 Location: Beaverton, OR, USA Posts: 10	best way to seal tygon/acrylic joint? I have an acrylic reservoir where I'm feeding some tygon r-1000 tubing out of the bottom (to feed the pump). The tygon and hole in the acrylic are the same size (1/2"), and the fit is pretty tight. What's the best sealant? I have some regular Home Depot GE Silicone II. Is there something better? Larry Lewis

06-28-2003, 04:07 PM	#2
Cyco-Dude Cooling Savant Join Date: Feb 2002 Location: Dayton, Ohio Posts: 836	well, you could try using plumbers goop. would it be possible to put a barb into the res??

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)