|
|
Heatsink/ Heat Pipe / ThermoSiphon Cooling The cat will only make the mistake of putting its paw by your HSF once. :) Also the place to discuss the new high end heat pipe goodness. |
Thread Tools |
03-15-2003, 02:08 PM | #1 |
Cooling Neophyte
Join Date: Mar 2003
Location: USA
Posts: 1
|
Noob Question on thermal pads...
Hello, I would like to upgrade my current heatsink and I believe I have a thermal pad right now. Is this pad permanently stuck to the proccessor and heatsink...or will it come off so I can attach a Volcano 7+ with thermal grease? Anyone have a walkthrough or site for this situation? Thanks!
|
03-15-2003, 06:38 PM | #2 |
Cooling Savant
Join Date: Sep 2002
Location: Cincinnati, OH
Posts: 229
|
Hey ilkramil,
Welcome to the forum... No, the thermal pad is not permanently stuck. You can use Goof-Off (Xylene) or fingernali polish remover (acetone) followed by a cleanup with isopropyl alcohol. Be very careful when working on the CPU die - just use a little solvent on the end of a Q-tip swap. Do not get on other things like the CPU package, socket or motherboard. Clean the bottom of your new heatsink the same way before applying a thin, even layer of thermal compound. Good luck, |
03-16-2003, 01:07 AM | #3 |
Cooling Savant
Join Date: Aug 2001
Location: Chippewa Falls, Wisconsin
Posts: 294
|
I second the welcome to the forums, and suggest that it is possible to do this without acetone or xylene (or toluene, etc, etc).
If your current heatsink has anything but a super-weak clip, you should have very little of the TIM on the top of your CPU (the layer should be so thin as to be little more than a discoloration), and just a little squished over the edges of the die. You should be able to get the edges clean with a toothpick or a dry q-tip, and followed by cleanup with isopropyl. As for the rest of the TIM on the heatsink, just use a pen cap and some patience, followed by more isopropyl. If you're in a big hurry, brake cleaner or WD-40 will knock the TIM right off of the heatsink. Be careful, though--they leave an oily residue that can be a pain to clean off later, especially from between the fins of your heatsink. |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
Thread Tools | |
|
|