|
|
Water Block Design / Construction Building your own block? Need info on designing one? Heres where to do it |
Thread Tools |
08-12-2006, 03:13 PM | #1 |
Cooling Neophyte
Join Date: Aug 2006
Location: SEATTLE
Posts: 1
|
What block for low profile application
Picture a pair of XFX 6800xt's with fans on a ASUS M2N32 MB. They crowd out the slots below them. If I remove the fans and replace with low profile water blocks, then plumb them into a mix and match cooling system, my slots will magically become available again.
The only block I have found is a Thermaltake W0088 which is 11mm thick. I would prefer half inch id nozzles but may have to settle for three eighths. Check it out: http://www.thermaltakeusa.com/produc...8/cl-w0088.asp It comes with compression fittings. Evercool also has a block but it might have aluminum in it? The all in one gpu and ram block are significantly more expensive. What do you think? |
08-13-2006, 03:45 PM | #2 |
Cooling Savant
Join Date: Jan 2006
Location: VA
Posts: 129
|
Re: What block for low profile application
Not the best place to ask this.
Thermaltake and Evercool (does not contain aluminum) make sub-par water-cooling equipment. And that kind of tubing arraingement will make it difficult to install RAMsinks. Have you looked at http://ekwaterblocks.com/shop/index.php?cPath=21_31 His full-cover are immaculate and around $80USD each. Just use http://www.xe.com to convert the prices. |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|