FS: My Main Rig... *Pics Posted*

jwill · 09-10-2004, 07:11 PM

Main Rig...

Hardware:
• AMD Athlon XP-M 2600+
• DFI Infinity nForce2
• 3x 256MB Mushkin Level 2 BH-5
• ATi 9800 Pro 128mb
• Antec TrueControl 550w
• Seagate Barracuda ATA IV 80gb 7200rpm
• TDK Internal E-IDE CD-RW 48/16/48
• Coolermaster Wavemaster Case
• Logitech Cordless MX Duo

Cooling:
• VGA: Arctic Cooling VGA Silencer Rev. 3 & OCZ Copper BGA Sinks
• CPU: Zalman CNPS7000A-Cu
• MB: Swiftech MCX159

OCs:
• CPU does 2625 at 250x10.5 at 1.95v.
• Motherboard does 250 FSB at 1.80v.
• Memory does 250 at 2-2-2-5 with 3.3v.
• Video does 420/380 at stock volts.

• CPU temps taken with Winbond's Hardware Doctor. Never went above 50c during load.

• 3dmark2001 benched at 250x10=2500mhz with 1.90v and 9800 Pro at 420/380...
21089 - http://service.futuremark.com/compare?2k1=8071295

• Super_PI bench... http://home.comcast.net/~jwill83/super_pi_36s.jpg

Posted at the "Super-PI Challenge!" on the bit-tech forum (11th down)...
http://forums.bit-tech.net/showthread.php?t=39994

Mods:
• Goal was for Clean and Quiet.
• Full Cable Sleeving.
• Super Clean Cable Managment.
• 2x UV Clear Round 10" Single E-IDE Cables.
• 2x 120mm Aluminum Case Fans added to top and bottom of case.
• 1x 80mm Aluminum Case Fan to replace stock back exhaust fan.
• 3x Front Mounted Switches to control the three aluminum case fans. Three settings 12v, 5v and off. The third switch is a little loose.
• TDK CD-RW Bezel replaced with stock blank cover.
• Window cut for CD-RW when in an acrylic case but never added actual window after wavemaster purchase. Anti-static bag taped over window to cover from dust.
• 2x Stock front fans removed after 120mm case fan improvement.
• Arctic Cooling VGA Silencer Power Cable modded to 4-pin molex connector to run directly off the power supply instead of the video card.
• Matching Tall Case Feet to improvent air supply to lower case fan.
• Zalman Fan Controller Double-Sided Foam Taped to motherboard surface.
• Chrome Door Molding surrounding cuts made for the 120mm fan improvement.
• Fans mounted with Fan Isolators (execpt the top), eight extra included.
• Hard Drive Suspended with Stretch Magic Elastic Cord for tight well secured vibration dampening.
• Antec Power Supply Control Panel removed from bay mounting and mounted to the inside chassis (out of sight) since the control panel bay mounting didnt match well with the case.
• Air Duct Cut into Coolermaster Side Door for Zalman CPU Cooler fresh air intake.

$1050 Shipped

• Manuals, Documents and cables needed are included.

• Weighing in at just over 30 pounds.

• Pics...

http://home.comcast.net/~jwill83/P1010002.JPG

http://home.comcast.net/~jwill83/P1010007.JPG

http://home.comcast.net/~jwill83/P1010006.JPG

________

Logitech Z-680 5.1 Surround Sound Speakers...

• A few scratches on the controller, nothing major.

Sold.

________

Microsoft XBox Package...

• Xbox Console (w/ Video and Power Cable)
• Xbox Live Starter Kit (w/ Headset and Software)
• Xbox Action Replay Kit (w/ Memory Card, USB Interface, Software and Manual)
• Two Original Xbox Remotes.
• MotoGP 2 (Online Enabled)
• Unreal Championship (Online Enabled)

$150 Shipped

________
________

• Money Order / Cashiers Check prefered method of payment.

• Shipping Priced are within the USA.

• Guaranteed non-doa.

jwill83 (a t) comcast (d o t) net

• AIM: jwill1337, Y!: jwill_1337

• heatware id = jwill

• PM me for more contact information if you need it.

• Thanks for looking.

jwill · 09-11-2004, 12:54 PM

main rig now priced with shipping included... $1200 shipped.

added super_pi bench.

xbox package soon to come.

jwill · 09-26-2004, 10:15 AM

final price drop... $1050 shipped.

edit: ive decided to hold on to the computer for now... sale postponed.

09-10-2004, 07:11 PM	#1
jwill Cooling Neophyte Join Date: Jul 2003 Location: vancouver, washington Posts: 14	FS: My Main Rig... Pics Posted Main Rig... Hardware: • AMD Athlon XP-M 2600+ • DFI Infinity nForce2 • 3x 256MB Mushkin Level 2 BH-5 • ATi 9800 Pro 128mb • Antec TrueControl 550w • Seagate Barracuda ATA IV 80gb 7200rpm • TDK Internal E-IDE CD-RW 48/16/48 • Coolermaster Wavemaster Case • Logitech Cordless MX Duo Cooling: • VGA: Arctic Cooling VGA Silencer Rev. 3 & OCZ Copper BGA Sinks • CPU: Zalman CNPS7000A-Cu • MB: Swiftech MCX159 OCs: • CPU does 2625 at 250x10.5 at 1.95v. • Motherboard does 250 FSB at 1.80v. • Memory does 250 at 2-2-2-5 with 3.3v. • Video does 420/380 at stock volts. • CPU temps taken with Winbond's Hardware Doctor. Never went above 50c during load. • 3dmark2001 benched at 250x10=2500mhz with 1.90v and 9800 Pro at 420/380... 21089 - http://service.futuremark.com/compare?2k1=8071295 • Super_PI bench... http://home.comcast.net/~jwill83/super_pi_36s.jpg Posted at the "Super-PI Challenge!" on the bit-tech forum (11th down)... http://forums.bit-tech.net/showthread.php?t=39994 Mods: • Goal was for Clean and Quiet. • Full Cable Sleeving. • Super Clean Cable Managment. • 2x UV Clear Round 10" Single E-IDE Cables. • 2x 120mm Aluminum Case Fans added to top and bottom of case. • 1x 80mm Aluminum Case Fan to replace stock back exhaust fan. • 3x Front Mounted Switches to control the three aluminum case fans. Three settings 12v, 5v and off. The third switch is a little loose. • TDK CD-RW Bezel replaced with stock blank cover. • Window cut for CD-RW when in an acrylic case but never added actual window after wavemaster purchase. Anti-static bag taped over window to cover from dust. • 2x Stock front fans removed after 120mm case fan improvement. • Arctic Cooling VGA Silencer Power Cable modded to 4-pin molex connector to run directly off the power supply instead of the video card. • Matching Tall Case Feet to improvent air supply to lower case fan. • Zalman Fan Controller Double-Sided Foam Taped to motherboard surface. • Chrome Door Molding surrounding cuts made for the 120mm fan improvement. • Fans mounted with Fan Isolators (execpt the top), eight extra included. • Hard Drive Suspended with Stretch Magic Elastic Cord for tight well secured vibration dampening. • Antec Power Supply Control Panel removed from bay mounting and mounted to the inside chassis (out of sight) since the control panel bay mounting didnt match well with the case. • Air Duct Cut into Coolermaster Side Door for Zalman CPU Cooler fresh air intake. $1050 Shipped • Manuals, Documents and cables needed are included. • Weighing in at just over 30 pounds. • Pics... http://home.comcast.net/~jwill83/P1010002.JPG http://home.comcast.net/~jwill83/P1010007.JPG http://home.comcast.net/~jwill83/P1010006.JPG ________ Logitech Z-680 5.1 Surround Sound Speakers... • A few scratches on the controller, nothing major. Sold. ________ Microsoft XBox Package... • Xbox Console (w/ Video and Power Cable) • Xbox Live Starter Kit (w/ Headset and Software) • Xbox Action Replay Kit (w/ Memory Card, USB Interface, Software and Manual) • Two Original Xbox Remotes. • MotoGP 2 (Online Enabled) • Unreal Championship (Online Enabled) $150 Shipped ________ ________ • Money Order / Cashiers Check prefered method of payment. • Shipping Priced are within the USA. • Guaranteed non-doa. jwill83 (a t) comcast (d o t) net • AIM: jwill1337, Y!: jwill_1337 • heatware id = jwill • PM me for more contact information if you need it. • Thanks for looking. Last edited by jwill; 09-26-2004 at 06:33 PM.

09-11-2004, 12:54 PM	#2
jwill Cooling Neophyte Join Date: Jul 2003 Location: vancouver, washington Posts: 14	main rig now priced with shipping included... $1200 shipped. added super_pi bench. xbox package soon to come. Last edited by jwill; 09-17-2004 at 01:38 AM. Reason: price drop.

09-26-2004, 10:15 AM	#3
jwill Cooling Neophyte Join Date: Jul 2003 Location: vancouver, washington Posts: 14	final price drop... $1050 shipped. edit: ive decided to hold on to the computer for now... sale postponed. Last edited by jwill; 10-05-2004 at 02:45 PM.

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)