well it seems that my amd mounting skills are a little rusty.
this morning i have tested both blocks again and first managed to lower the cup block temp by 1C but also the maze 3 by 3C making the cup block only 2C lower. this brings it close to the temp differances i had on the p4. |
Quote:
http://www.customcooledpc.com/jet3b/011.jpg http://www.customcooledpc.com/jet3b/001.jpg |
I recon there's too much wall thickness between the cups. The flat bottom is the only spot you'll get any impingment and maybe a bit at the bottom of the \ / shape. The walls will 'suck up' heat and raise the temp/delta. I think idealy you want a 0.25mm wall in the same pattern without the sloped walls...
|
| All times are GMT -5. The time now is 10:36 AM. |
Powered by vBulletin® Version 3.7.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
(C) 2005 ProCooling.com If we in some way offend you, insult you or your people, screw your mom, beat up your dad, or poop on your porch... we're sorry... we were probably really drunk... Oh and dont steal our content bitches! Don't give us a reason to pee in your open car window this summer...