Pro/Forums
Page 2 of 2 < 1 2
Show 30 post(s) from this thread on one page

Pro/Forums (http://forums.procooling.com/vbb/index.php)
-   General Liquid/Water Cooling Discussion (http://forums.procooling.com/vbb/forumdisplay.php?f=9)
-   -   Direct Heat Spreader Cooler (http://forums.procooling.com/vbb/showthread.php?t=14751)

compro 05-13-2008 08:32 AM
Re: Direct Heat Spreader Cooler
 
My e4400 idles at about 28c but when running prime it does go up near 50 no overclock, I always that the difrence was a bit extream.

Thats with vary good air cooling, but the clamp is not atched.

billbartuska 05-14-2008 06:49 AM
Re: Direct Heat Spreader Cooler
 
Quote:
Originally Posted by derelict
/offtopic

(I have some serious bendage going on with my mobo). I'm also wondering if that bending of the motherboard is causing poor contact for my hsf and processor

When I took the HSF off a week ago to test a different processor, I found that only a small sliver of the processor's arctic silver was actually disturbed/used.
The "bendage" itself isn't causing the problem. The CPU doesn't bend. Though the bending may be causing the HS to contact something on the motherboard and thus not seat properly. Yes, the thingey of the bottom of the motherboard is there to prevent the bending.

The poor TIM contact is likely the cause of your heat problem. The rapid rise in temps is typical of poor HS/CPU contact. Have a very close look at the HS and see if it's hitting something.


All times are GMT -5. The time now is 04:37 PM.
Page 2 of 2 < 1 2
Show 30 post(s) from this thread on one page

Powered by vBulletin® Version 3.7.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
(C) 2005 ProCooling.com
If we in some way offend you, insult you or your people, screw your mom, beat up your dad, or poop on your porch... we're sorry... we were probably really drunk...
Oh and dont steal our content bitches! Don't give us a reason to pee in your open car window this summer...