Well that is what I have been using for my metal top blocks. It works just great. I didn't know there was a clear version. I am going to have to look into that.

Thanks Peter!!!

question for all u acrylic gods...how the hell do i get these barbs to say in this acrylic...they keep popin out of my air trap when i go to put tubing on...wuz using silicon and it aint working...wnat to keep it clear as possible for looks....

Hey Haddy,

Well the NPT thread, as you know, is tapered. So the 1st thing to know is how far down you must screw the fitting before it begins to engage the thread.

On our tops, the engagement is very deep so that the fittings sit squarely on the top AND so that people don't over tighten the fittings and lift the top.

I have experimented with several leaking proofing items. IMO the good old pipe tape is the best. Simply make a few extra wraps to help 'tighten' up the thread a bit. If the threads are at the proper depth, one or two wraps makes a seal that can't be turned by hand.

One last tip is to NEVER put the tubing on dry and NEVER turn the tubing CCW when pushing it on. Wet the end and it will slide on easily.

Hope that helps.

You are threading the hole right? If not do it. Otherwise they will just shoot out of the hole. And what GeminiCool said was good advice. Especially when doing a water block never run the barb below the bottom of the acrylic or what ever material you are using as it will not fit flush. And if the top is already attached it WILL pop the top off if it is Epoxy or silicone. Been there done that.:D

Warning Newbie Watercooler Post!
 

Few questions

Will the spir@l (not gemini) have that DTek logo on the acrylic or will it be flat/clear like the gemini's?

What are O-rings, how do they protect better against leakage?

What are those bars ppl are talking about?

sorry for new newbie questions, i'll be setting up my first watercooled system and want to learn the lingo and how everything works. BTW, the spir@l is huge!

Need tests!!

thanks :)

Re: Warning Newbie Watercooler Post!
 

O rings are a rubber round gasket. They work very well. In fact i just changed the water pump on my Honda Accord and it uses an O ring to seal it. If it works for cars water pumps it will work for computer water blocks.

those bars I assume are barbs, which is what the hose connect to on the waterblock.

I think all the new Spirals have the DTEK logo on them. You maybe able to get a plain top through Fixittt though.