questions about constructing waterblocks(noob)
Hello Everyone! :D watercooling noob here :p I have some questions(stupid) to ask :D
I'm planning to construct a new waterblock(after getting sick of those noisy high rpm fans) 1. I don't have any mills. Can i construct a waterblock using drills, may be hard to control i guess? 2. If the above answer is yes, is there any simple waterblock designs for noobs? easier to build :P |
Search for #rotor blocks
|
you could use a drill, but like you suspect, it would be hard to controll, what would work much better is a drill press. and look for the type etacovda suggested, its a good starting point, but feel free to ask questions and try to figure out the ideas behind block design.
|
Thanks a lot for the input :D I browsed through this forums.....wow! some of you make really awesome waterblcoks! two thumbs up!
ah, looks like rotor blocks are easier to work with :D er....how about the thickness of the waterblock :D |
1 Attachment(s)
http://www.overclockers.com/articles678/
I did this with a 1/4" base which was also drilled into with a dremel tool wheel to make a little grid over the cpu area. |
oh sorry, i mean the thickness of the waterblock's base :D
|
| All times are GMT -5. The time now is 12:58 AM. |
Powered by vBulletin® Version 3.7.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
(C) 2005 ProCooling.com If we in some way offend you, insult you or your people, screw your mom, beat up your dad, or poop on your porch... we're sorry... we were probably really drunk... Oh and dont steal our content bitches! Don't give us a reason to pee in your open car window this summer...