Froth and bleeding
hey guys i got my WCing stuff today.. connected everything in a loop, Pump >> CPU >> Rad >> Res >> Pump.. Then measured the Distilled water and Zerex(1:20) quantity and slowly filled the res. The Pump(Eheim 1250) is running fine, but there is a lot of froth in the water.. I have opened an inlet in the res so that air can rise up.. the whole circuit is running fine, no leaks.. but i'm concerned about the froth and bubbles.. does it always froth in new setup? and how long does it take to bleed? I'm goin to leave this on for next 24 hours.
thanks. |
Give it time.
You may be experiencing some head from the residue left either inside the pump, or inside the tubing (from manufacturing). It should clear up within a day or two. It might stain your tubes (leave a residue), so you might want to look into Airspirit's Pine-Sol cleaning mixture :D |
| All times are GMT -5. The time now is 06:23 PM. |
Powered by vBulletin® Version 3.7.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
(C) 2005 ProCooling.com If we in some way offend you, insult you or your people, screw your mom, beat up your dad, or poop on your porch... we're sorry... we were probably really drunk... Oh and dont steal our content bitches! Don't give us a reason to pee in your open car window this summer...