Swiftech H20-120 Kit @ 3DGameman
Uh... BillA, I have a question for you? When people do reviews of your products, especially video reviews where you can see what they are doing, aren't they supposed to at least plumb the block properly? Last I checked, according to Swiftech documentation, the center barb was the inlet. Not the offcenter one. As well, since when does a review need 9 minutes of showing how to install the kit, and 30 seconds of discussion on the performance show proper balance? I mean, there was zero discussion on how he got temps, what he used for load, etc etc (the usual beefs). Watching this I felt my intelligence was being insulted.
Video Review |
Well, it appears he did follow things as the documentation told him to.
http://www.3dgameman.com/vr/swiftech...0/DSC07392.jpg But that picture doesn't quite jive with this: http://www.sci04alumni.ca/Random/swiftech6000.JPG Am I missing something? |
You're quite right. In the first picture the routing is showing this:
pump outlet->reservoir->waterblock outlet->radiator->pump inlet Someone needs to correct the first diagram. |
shall be done ASAP
jeez |
here is the skinny
this dwg was corrected in July (after one week) not too sure how this got out, but it clearly is incorrect all about QC again Thanks DMOS |
does it just seem he buys out the companies, no?
|
Quote:
|
http://www.3dgameman.com/forums/show...216#post430216
Rodney replied to the thread phaestus, in case you wanted to reply to him again. |
All times are GMT -5. The time now is 03:34 PM. |
Powered by vBulletin® Version 3.7.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
(C) 2005 ProCooling.com If we in some way offend you, insult you or your people, screw your mom, beat up your dad, or poop on your porch... we're sorry... we were probably really drunk... Oh and dont steal our content bitches! Don't give us a reason to pee in your open car window this summer...