my setup (pics)
 

Hi, i have now revised the setup and removed as many problems as i could from it previously

Here we go:


storm G4

silverprop HL

AQX 50z pump with oversized fittings (1/2" ID, 5/8" OD)

120.3 with 1 inch stand off

panaflow M1's

tygon r1000

oversized t piece (1/2" ID)

DD fillport


http://img.photobucket.com/albums/v2...y/IMG_0720.jpg


http://img.photobucket.com/albums/v2...y/IMG_0727.jpg


http://img.photobucket.com/albums/v2...y/IMG_0729.jpg


http://img.photobucket.com/albums/v2...y/IMG_0718.jpg



http://img.photobucket.com/albums/v2...y/IMG_0730.jpg



http://img.photobucket.com/albums/v2...y/IMG_0717.jpg



im crap with a cam but it gives you a good idea, what do you think?

Cheers

mike


here is a link to my previous setup http://forums.procooling.com/vbb/showthread.php?t=11151

Hows your overclock with that dfi board?
Looks nice

311x9 prime stable 1.65v, A64 3000 48 spaw

looks good man... bit of an improvement from your last pics you posted.

cheers mate, tryed to everything i could, i didnt actual;ly realise the swiftech hydrx was green lol, knew it was uv but as i have no cathodes assumed it would be nice and clear

though for $3 i think its great, purple ice stained my tubes something stupid, i only got it as PIce was low and i was ordering the r1000 from sidewinders so chucked it in

Nice lookin rig. Personally I wouldn't have used ah HL with that G4 since they are both pretty restrictive. I woulda used a much less restrictive maze4 GPU and sacrificed a few degrees on the GPU so I could get all the CPU performance that beastly G4 would allow. Just my opinion, I am sure you are very happy with it either way :D

had crossed my mind but i previously used a 6002 with the HL so was a good match

Then i managed to grab a G4 from cathar and have stuck with the HL, has the test on maze4 vs HL gone underway yet btw?