Machining tolerances of Al...
just a quick question for those who might know: are the machining tolerances for Al any tighter than Cu? e.g. could one have a thinner base by using Al vs. Cu? FYI I'm not trying to start "the same old debat" again. I'm just curious as it pertains to a specific project that I might undertake.
|
| All times are GMT -5. The time now is 06:41 PM. |
Powered by vBulletin® Version 3.7.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
(C) 2005 ProCooling.com If we in some way offend you, insult you or your people, screw your mom, beat up your dad, or poop on your porch... we're sorry... we were probably really drunk... Oh and dont steal our content bitches! Don't give us a reason to pee in your open car window this summer...