Need G1/4" Thread to 1/2" ID tubing
 

Barb or Elbow Barb.

Wondering where I could get this from Canada/USA for an Alphacool NexXxoS NVXP-3 block. Need to connect the block to a 1/2"ID system.
Should look like this...
http://www.alphacool.de/xt/images/pr...ges/3322_0.jpg

Very important.

Block Info:
Alphacool NVXP-3
Technical data:

Overall dimensions (without connections):
Length 91 mm, Width 136 mm, Height 24 mm
Weight: 482 gr.
Connections: G1/4"


Thanks guys..

BTW it's the same type of fitting that would fit this..

http://www.frozencpu.com/ex-res-82.html?id=ThcnZnJa

Re: Need G1/4" Thread to 1/2" ID tubing
 

Looks like I found them

Danger Den High Flow fittings

http://www.performance-pcs.com/catal...cts/G14_12.jpg

Dirt Cheap too..:)

Re: Need G1/4" Thread to 1/2" ID tubing
 

No I found them :D Don't lie!

Re: Need G1/4" Thread to 1/2" ID tubing
 

Yeah.. thanks for that... gonna be ubber nice to have those setup on my block.

Next thing is a new reservoir. This Criticool Waterplant is getting a little old now.

Re: Need G1/4" Thread to 1/2" ID tubing
 

Try ...

http://www.usplastic.com/catalog/pro...duct%5Fid=8136

http://www.usplastic.com/catalog/pro...duct%5Fid=7957

Even a better option ... :cool:

http://www.usplastic.com/catalog/pro...duct%5Fid=7790

And if you want to poke around the site for other fittings ...

http://www.usplastic.com/catalog/cat...e=18309&Page=1

Re: Need G1/4" Thread to 1/2" ID tubing
 

stev, usplastics only carries NPT threaded fittings, no BSPP.

Re: Need G1/4" Thread to 1/2" ID tubing
 

Now that is a bummer. :doh:

Stev